Archive

Posts Tagged ‘kitchen’

Pot Filler

August 3rd, 2010 admin No comments

Pot Filler
When a load height must be installed on the boat behind the stove?

I have a Jenn Air double oven with a load go POT wall. Only has a valve, but how high should be in the back of the range that is 46 inches tall.

I suggest you go buy this great copper pot expensive and definitely make sure that is bigger than that! Seriously, should not only be large enough to meet his biggest pot low?

Categories: plumbing Tags: , , , ,

Sprayer Kitchen

July 31st, 2010 admin No comments

Sprayer Kitchen
How I can get the pipe to the water line to attract more in the sprayer on the kitchen faucet? Remove sink faucet?

There a kitchen faucet with a sprayer to shoot. An installation hole. The spray hose and I broke the power of a new pipe line of water, but does not seem appropriate. When the old hose off, it was through, under the sink, but I can not get the new pipe down and they have the same size. Should I remove sink faucet set to feed through the tube?

If u disconnect the old hose … u must have permission to put new submarines. Most are standard, and should not give u any problem. Good luck. Question … How old is broken? Water should not have enough pressure to burst. U pressure should be checked at home … is 65 pounds. and no more. If u more, u should think of a pressure regulator for the house.

Categories: plumbing Tags: , , , ,

Bronze Marielle

July 29th, 2010 admin No comments

Bronze Marielle

Stainless Overmount

July 28th, 2010 admin No comments

Stainless Overmount
I heard that you should not install a stainless steel sink in granite counters overmount, why?

as there is no reason why can imagine. the only question that could be cut and the (self-rimming) overmount sink is larger than one would be one color and the room as the cut is lower .. But once inside, I think they have the same integrity. Why would a steel concern, not a porcelain sink is beyond me.

Categories: plumbing Tags:

Handle Pull

July 27th, 2010 admin No comments

Handle Pull
soldering is a handle that could get?

I am refurbishing the metal cabinet of old really great. Lock the door is gone, leaving behind a beautiful and large have approximately 3 / 4 "diameter. I do not really need a lock, and the thing is closed decently well. Is it possible to fill that hole, then use an ordinary door to pull it, or it is a super large drawer pull rod that would work?

Buy a lock for replacement in a shelter or find a drawer pull knob covering the hole and use a large washer with a small hole to retrieve the screw — on the back are called rings of protection "at hardware or home center —- transported.

Categories: plumbing Tags: , , , ,